Not written yet. This page only shows what Musa CAD itself reports about this item. The rest has not been written yet.
TRIMMODE
Not written yetmade from Musa CAD's own dataChecked against Musa CAD 0.8.0Verified
Whether FILLET and CHAMFER trim the objects to the corner (1) or leave them as they are (0).
- Type
- TRIMMODE
- Starts as
1- Since
- Musa CAD 0.8.0
How to set it
Command: TRIMMODEEnter new value for TRIMMODE <1>:Read from Musa CAD 0.8.0 itself (musacad --dump-wiki-data), so these facts always match the release this wiki is built for (0.8.0).