Not written yet. This page only shows what Musa CAD itself reports about this item. The rest has not been written yet.
TRIMEXTENDMODE
Not written yetmade from Musa CAD's own dataChecked against Musa CAD 0.8.0Verified
TRIM and EXTEND's mode: 1 Quick (every object an edge), 0 Standard (edges chosen first).
- Type
- TRIMEXTENDMODE
- Starts as
1- Since
- Musa CAD 0.7.0
How to set it
Command: TRIMEXTENDMODEEnter new value for TRIMEXTENDMODE <1>:Read from Musa CAD 0.8.0 itself (musacad --dump-wiki-data), so these facts always match the release this wiki is built for (0.8.0).