Not written yet. This page only shows what Musa CAD itself reports about this item. The rest has not been written yet.
SPLINESEGS
Not written yetmade from Musa CAD's own dataChecked against Musa CAD 0.8.0Verified
The straight pieces a segment of a spline-fit polyline is drawn with (PEDIT Spline).
- Type
- SPLINESEGS
- Starts as
8- Since
- Musa CAD 0.8.0
How to set it
Command: SPLINESEGSEnter new value for SPLINESEGS <8>:Read from Musa CAD 0.8.0 itself (musacad --dump-wiki-data), so these facts always match the release this wiki is built for (0.8.0).