Not written yet. This page only shows what Musa CAD itself reports about this item. The rest has not been written yet.
PELLIPSE
Not written yetmade from Musa CAD's own dataChecked against Musa CAD 0.8.0Verified
1 makes ELLIPSE draw a polyline of arcs, 0 a true ellipse.
- Type
- PELLIPSE
- Starts as
0- Since
- Musa CAD 0.7.0
How to set it
Command: PELLIPSEEnter new value for PELLIPSE <0>:Read from Musa CAD 0.8.0 itself (musacad --dump-wiki-data), so these facts always match the release this wiki is built for (0.8.0).