Not written yet. This page only shows what Musa CAD itself reports about this item. The rest has not been written yet.
PEDITACCEPT
Not written yetmade from Musa CAD's own dataChecked against Musa CAD 0.8.0Verified
Whether PEDIT turns a line or arc picked into a polyline without asking (1) or asks (0).
- Type
- PEDITACCEPT
- Starts as
0- Since
- Musa CAD 0.8.0
How to set it
Command: PEDITACCEPTEnter new value for PEDITACCEPT <0>:Read from Musa CAD 0.8.0 itself (musacad --dump-wiki-data), so these facts always match the release this wiki is built for (0.8.0).