Not written yet. This page only shows what Musa CAD itself reports about this item. The rest has not been written yet.
OFFSETGAPTYPE
Not written yetmade from Musa CAD's own dataChecked against Musa CAD 0.8.0Verified
What joins a polyline's segments where an offset has parted them: 0 extend, 1 arc, 2 bevel.
- Type
- OFFSETGAPTYPE
- Starts as
0- Since
- Musa CAD 0.6.0
How to set it
Command: OFFSETGAPTYPEEnter new value for OFFSETGAPTYPE <0>:Read from Musa CAD 0.8.0 itself (musacad --dump-wiki-data), so these facts always match the release this wiki is built for (0.8.0).