Not written yet. This page only shows what Musa CAD itself reports about this item. The rest has not been written yet.
MEASUREINIT
Not written yetmade from Musa CAD's own dataChecked against Musa CAD 0.8.0Verified
Imperial (0) or metric (1): what a new drawing's MEASUREMENT starts as.
- Type
- MEASUREINIT
- Starts as
1- Since
- Musa CAD 0.8.0
How to set it
Command: MEASUREINITEnter new value for MEASUREINIT <1>:Read from Musa CAD 0.8.0 itself (musacad --dump-wiki-data), so these facts always match the release this wiki is built for (0.8.0).