Not written yet. This page only shows what Musa CAD itself reports about this item. The rest has not been written yet.
HPSEPARATE
Not written yetmade from Musa CAD's own dataChecked against Musa CAD 0.8.0Verified
Whether one HATCH makes one hatch of the areas picked or selected (0), or one each (1).
- Type
- HPSEPARATE
- Starts as
0- Since
- Musa CAD 0.8.0
How to set it
Command: HPSEPARATEEnter new value for HPSEPARATE <0>:Read from Musa CAD 0.8.0 itself (musacad --dump-wiki-data), so these facts always match the release this wiki is built for (0.8.0).