Not written yet. This page only shows what Musa CAD itself reports about this item. The rest has not been written yet.
FILLMODE
Not written yetmade from Musa CAD's own dataChecked against Musa CAD 0.8.0Verified
Whether wide polylines, solids and hatches are filled (1) or outlined (0).
- Type
- FILLMODE
- Starts as
1- Since
- Musa CAD 0.6.0
How to set it
Command: FILLMODEEnter new value for FILLMODE <1>:Read from Musa CAD 0.8.0 itself (musacad --dump-wiki-data), so these facts always match the release this wiki is built for (0.8.0).