Not written yet. This page only shows what Musa CAD itself reports about this item. The rest has not been written yet.
EDGEMODE
Not written yetmade from Musa CAD's own dataChecked against Musa CAD 0.8.0Verified
Whether TRIM and EXTEND's chosen edges count along their extension (1) or only as drawn (0).
- Type
- EDGEMODE
- Starts as
0- Since
- Musa CAD 0.7.0
How to set it
Command: EDGEMODEEnter new value for EDGEMODE <0>:Read from Musa CAD 0.8.0 itself (musacad --dump-wiki-data), so these facts always match the release this wiki is built for (0.8.0).