Not written yet. This page only shows what Musa CAD itself reports about this item. The rest has not been written yet.
DYNPROMPT
Not written yetmade from Musa CAD's own dataChecked against Musa CAD 0.8.0Verified
Dynamic Input shows the command's prompt at the cursor (1) or only the value (0).
- Type
- DYNPROMPT
- Starts as
1- Since
- Musa CAD 0.8.0
How to set it
Command: DYNPROMPTEnter new value for DYNPROMPT <1>:Read from Musa CAD 0.8.0 itself (musacad --dump-wiki-data), so these facts always match the release this wiki is built for (0.8.0).