Not written yet. This page only shows what Musa CAD itself reports about this item. The rest has not been written yet.
DYNPIFORMAT
Not written yetmade from Musa CAD's own dataChecked against Musa CAD 0.8.0Verified
Pointer input shows a next point polar (0, distance<angle) or Cartesian (1, x,y).
- Type
- DYNPIFORMAT
- Starts as
0- Since
- Musa CAD 0.8.0
How to set it
Command: DYNPIFORMATEnter new value for DYNPIFORMAT <0>:Read from Musa CAD 0.8.0 itself (musacad --dump-wiki-data), so these facts always match the release this wiki is built for (0.8.0).