Not written yet. This page only shows what Musa CAD itself reports about this item. The rest has not been written yet.
DYNPICOORDS
Not written yetmade from Musa CAD's own dataChecked against Musa CAD 0.8.0Verified
Dynamic Input's second and next points as relative (0) or absolute (1) coordinates.
- Type
- DYNPICOORDS
- Starts as
0- Since
- Musa CAD 0.8.0
How to set it
Command: DYNPICOORDSEnter new value for DYNPICOORDS <0>:Read from Musa CAD 0.8.0 itself (musacad --dump-wiki-data), so these facts always match the release this wiki is built for (0.8.0).