Not written yet. This page only shows what Musa CAD itself reports about this item. The rest has not been written yet.
MVIEW
Not written yetmade from Musa CAD's own dataChecked against Musa CAD 0.8.0Verified
A viewport on the layout showing model space: two corners or Fit; ON, OFF, Scale, Center.
- Type
- MVIEW or MV
- On the ribbon
- Not on the ribbon. Type it, or find it with the command search above the ribbon.
- Since
- Musa CAD 0.4.0
What it says
Command: MVIEWMVIEW works on a layout: pick a layout tab (or LAYOUT Set) first.Read from Musa CAD 0.8.0 itself (musacad --dump-wiki-data), so these facts always match the release this wiki is built for (0.8.0).