Not written yet. This page only shows what Musa CAD itself reports about this item. The rest has not been written yet.
MULTIPLE
Not written yetmade from Musa CAD's own dataChecked against Musa CAD 0.8.0Verified
Repeat a command until Esc (MULTIPLE POINT places point after point).
- Type
- MULTIPLE
- On the ribbon
- Home › Draw (slide-out) › Point › Multiple Points
- Since
- Musa CAD 0.8.0
What it asks first
Command: MULTIPLEEnter command name to repeat:Read from Musa CAD 0.8.0 itself (musacad --dump-wiki-data), so these facts always match the release this wiki is built for (0.8.0).