Not written yet. This page only shows what Musa CAD itself reports about this item. The rest has not been written yet.
IMAGECLIP
Not written yetmade from Musa CAD's own dataChecked against Musa CAD 0.8.0Verified
Clip an image to a rectangular boundary, or delete, switch on or off its boundary.
- Type
- IMAGECLIP or ICL
- On the ribbon
- Insert › Reference › Clip
- Since
- Musa CAD 0.4.0
What it asks first
Command: IMAGECLIPSelect image to clip:Read from Musa CAD 0.8.0 itself (musacad --dump-wiki-data), so these facts always match the release this wiki is built for (0.8.0).