Not written yet. This page only shows what Musa CAD itself reports about this item. The rest has not been written yet.
DONUT
Not written yetmade from Musa CAD's own dataChecked against Musa CAD 0.8.0Verified
Draw a filled ring (or disc) from inside/outside diameters.
- Type
- DONUT or DO
- On the ribbon
- Home › Draw (slide-out) › Donut
- Since
- Musa CAD 0.4.0
What it asks first
Command: DONUTSpecify inside diameter of donut <0.5000>:Read from Musa CAD 0.8.0 itself (musacad --dump-wiki-data), so these facts always match the release this wiki is built for (0.8.0).