Not written yet. This page only shows what Musa CAD itself reports about this item. The rest has not been written yet.
DIMINSPECT
Not written yetmade from Musa CAD's own dataChecked against Musa CAD 0.8.0Verified
Make the selected dimensions inspection dimensions: a frame, a label and an inspection rate.
- Type
- DIMINSPECT
- On the ribbon
- Annotate › Dimensions (slide-out) › Inspect
- Since
- Musa CAD 0.8.0
What it asks first
Command: DIMINSPECTSelect dimensions:Read from Musa CAD 0.8.0 itself (musacad --dump-wiki-data), so these facts always match the release this wiki is built for (0.8.0).