Not written yet. This page only shows what Musa CAD itself reports about this item. The rest has not been written yet.
DIMCENTER
Not written yetmade from Musa CAD's own dataChecked against Musa CAD 0.8.0Verified
Mark the centre of an arc or circle, with centre lines if asked.
- Type
- DIMCENTER or DCE
- On the ribbon
- Not on the ribbon. Type it, or find it with the command search above the ribbon.
- Since
- Musa CAD 0.7.0
What it asks first
Command: DIMCENTERSelect arc or circle or [Lines] <mark only>:Read from Musa CAD 0.8.0 itself (musacad --dump-wiki-data), so these facts always match the release this wiki is built for (0.8.0).