Skip to content
Musa CAD Wiki

Reading settings

Theme
Text size
Line spacing
Reading width
Code text size
Dyslexia-friendly font · Motion
Blog

Not written yet. This page only shows what Musa CAD itself reports about this item. The rest has not been written yet.

CENTERMARK

Not written yetmade from Musa CAD's own dataChecked against Musa CAD 0.8.0Verified

Mark the centres of circles and arcs, with centre lines.

Type
CENTERMARK or CM
On the ribbon
  • Annotate › Dimensions (slide-out) › Center Mark

What it asks first

Command line
Command: CENTERMARK
Select circle or arc to add centermark:

Read from Musa CAD 0.8.0 itself (musacad --dump-wiki-data), so these facts always match the release this wiki is built for (0.8.0).