Not written yet. This page only shows what Musa CAD itself reports about this item. The rest has not been written yet.
BREAKATPOINT
Not written yetmade from Musa CAD's own dataChecked against Musa CAD 0.8.0Verified
Split a curve at one point, leaving no gap.
- Type
- BREAKATPOINT
- On the ribbon
- Home › Modify (slide-out) › Break at Point
- Since
- Musa CAD 0.4.0
What it asks first
Command: BREAKATPOINTSelect object:Read from Musa CAD 0.8.0 itself (musacad --dump-wiki-data), so these facts always match the release this wiki is built for (0.8.0).