Not written yet. This page only shows what Musa CAD itself reports about this item. The rest has not been written yet.
BASE
Not written yetmade from Musa CAD's own dataChecked against Musa CAD 0.8.0Verified
Set the drawing's insertion base point: where it sits when inserted into another drawing.
- Type
- BASE
- On the ribbon
- Insert › Block › Set Base Point
- Since
- Musa CAD 0.8.0
What it asks first
Command: BASEEnter base point <0.0000,0.0000,0.0000>:Read from Musa CAD 0.8.0 itself (musacad --dump-wiki-data), so these facts always match the release this wiki is built for (0.8.0).